Delete Cpu Access_Profile; To Create A Cpu Access Profile - D-Link DES-3010F Command Line Interface Reference Manual

create cpu access_profile
Restrictions
Example usage:

To create a cpu access profile:

DES-3026:4#create cpu access_profile profile_id 1 ip vlan source_ip_mask
20.0.0.0 destination_ip_mask 10.0.0.0 dscp icmp type code
Command: create cpu access_profile profile_id 1 ip vlan source_ip_mask
20.0.0.0 destination_ip_mask 10.0.0.0 dscp icmp type code
Success.
DES-3026:4#

delete cpu access_profile

Purpose
Syntax
Description
DES-30XX Layer 2 Switch CLI Reference Manual
packet_content_mask – Specifies that the Switch will mask the packet
header beginning with the offset value specified as follows:
offset_0-15 - Enter a value in hex form to mask the packet from
•
byte 0 to byte 15.
offset_16-31 - Enter a value in hex form to mask the packet from
•
byte 16 to byte 31.
offset_32-47 - Enter a value in hex form to mask the packet from
•
byte 32 to byte 47.
offset_48-63 - Enter a value in hex form to mask the packet from
•
byte 48 to byte 63.
offset_64-79 - Enter a value in hex form to mask the packet from
•
byte 64 to byte 79.
ipv6 – Denotes that IPv6 packets will be examined by the Switch for
forwarding or filtering based on the rules configured in the config cpu
access_profile command for IPv6. IPv6 packets may be identified by the
following:
class – Entering this parameter will instruct the Switch to examine
•
the class field of the IPv6 header. This class field is a part of the
packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
flowlabel – Entering this parameter will instruct the Switch to
•
examine the flow label field of the IPv6 header. This flow label field
is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
source_ipv6_mask <ipv6mask> - Specifies an IP address mask for
•
the source IPv6 address.
destination_ipv6_mask <ipv6mask> - Specifies an IP address mask
•
for the destination IPv6 address.
Only administrator-level users can issue this command.
Used to delete a previously created access profile or CPU access profile.
delete cpu access_profile profile_id <value 1-3>
The delete cpu access_profile command is used to delete a previously
t d CPU fil
116