D-Link DES-3010F Command Line Interface Reference Manual page 70

config syslog host
Restrictions
Example usage:
To configure a syslog host:
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
DES-30XX Layer 2 Switch CLI Reference Manual
local4 − Specifies that local use 4 messages will be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that
the syslog protocol will use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address of the remote host
where syslog messages will be sent.
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Only administrator-level users can issue this command.
DES-3026:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3026:4#
Used to remove a syslog host, that has been previously configured,
from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog host
that has been previously configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Only administrator-level users can issue this command.
DES-3026:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3026:4#
66