Config 802.1X Auth_Protocol; Config 802.1X Init; To Configure The Authentication Protocol On The Switch - D-Link DES-3010F Command Line Interface Reference Manual

Managed 8/16/24-port 10/100mbps n-way fast ethernet switch
Hide thumbs Also See for DES-3010F:
Table of Contents

Advertisement

To configure 802.1x authentication parameters for ports 1 – 20:
DES-3026:4#config 802.1x auth_parameter ports 1 – 20 direction both
Command: config 802.1x auth_parameter ports 1 – 20 direction both
Success.
DES-3026:4#

config 802.1x auth_protocol

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure the authentication protocol on the Switch:

DES-3026:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DES-3026:4#

config 802.1x init

Purpose
Syntax
Description
Parameters
DES-30XX Layer 2 Switch CLI Reference Manual
Used to configure the 802.1x authentication protocol on the
Switch.
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables you to
configure the authentication protocol.
[local | radius_eap] – Specify the type of authentication protocol
desired.
Only administrator-level users can issue this command.
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports
[<portlist> | all] {mac_address <macaddr>}]
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
port_based ports – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can then be
specified.
<portlist> − Specifies a port or range of ports to be initialized.
all − Specifies all of the ports on the Switch to be initialized.
mac_based - This instructs the Switch to initialize 802.1x functions based
on the MAC address of a device on a specific port or range of ports. MAC
address approved for initialization can then be specified.
ports <portlist> − Specifies a port or range of ports.
all − Specifies all of the ports on the Switch.
134

Advertisement

Table of Contents
loading

This manual is also suitable for:

3010g - des switchDes-3010gDes-3018Des-3026

Table of Contents