Removing The Blackdiamond 10808 Switch Fan Tray - Extreme Networks BlackDiamond 10K Series Installation Manual

BlackDiamond 10808 Switch Fan Tray and Filter
ExtremeWare monitors the fan trays in the BlackDiamond 10808 switch for overheat conditions. All
over temperature events cause the switch to send alerts to the network management station or to the
switch log. See the ExtremeWare XOS Concepts Guide for more information about switch monitoring.

Removing the BlackDiamond 10808 Switch Fan Tray

BlackDiamond 10808 switch fan trays are hot-swappable. You do not need to turn off power to an
BlackDiamond 10808 switch to remove a fan tray.
You need the following tools and equipment to remove a fan tray:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
CAUTION
Only trained service personnel should perform service to BlackDiamond 10808 switch fan trays. Before
installing or removing any components, or carrying out any maintenance procedures, see Appendix A.
To remove the fan tray from the BlackDiamond 10808 switch:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-right corner of the switch front panel.
2 Unscrew the two captive screws that secure the fan tray to the chassis by turning them
counterclockwise (to the left).
3 Use the finger grips to pull the fan tray out of the chassis approximately 1 inch (2.54 cm); this step
disconnects the power and causes the fans to stop rotating.
88 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide