Canon imageCLASS MF5850dn Basic Operation Manual page 156

– Only one destination can be specified using
– , [numeric keys] and
sure to press [OK] after entering the recipient's
number.
– After specifying destinations other than fax
numbers using one-touch keys or coded dial
codes, you cannot specify a fax number using
– , [numeric keys] and
– If <CONFIRM FAX NO.> in <ACCESS TO DEST.>
in <SYSTEM SETTINGS> is set to <ON> and you
specify a fax number using
keys] and [Tone], you must enter the fax
number again for confirmation. Enter the same
fax number you entered in step 4, then press
[OK].
5
Repeat step 4 to enter all required
recipients.
– To check all the specified destinations, press
or to scroll the display.
– To cancel all the specified destinations, press
[Stop/Reset].
6
Press [Start].
When you place the documents on the platen
glass, press or
size, then press
When scanning is complete, press [OK] to start
sending.
When <TIME OUT> is set to <ON> in <TX
SETTINGS> in <FAX SETTINGS> in <TX/RX
SETTINGS>, and if you have specified the
destination by any other method than using
, [numeric keys] and
starts scanning automatically without pressing
[Start], after the preset time for this setting is
elapsed. (See "Time Out Mode, " on p. 6-41.)
[Tone]. Make
[Tone].
– , [numeric
to select the document
[Start] for each document.
–
[Tone], the machine
Specifying Destinations
6-25