Static Route Configuration Example - 3Com 3032 Configuration Manual

412 C 27: C
HAPTER ONFIGURING
Static Route
Configuration
Example
Troubleshooting a
Static Route
Configuration
S R
TATIC OUTES
By configuring a status route, any two hosts or routes can communicate with each
other.
Figure 144 Example of static route configuration
E0
1.1.1.2
Host1 1.1.1.1
To configure a static route:
1 Configure the static route for RouterA:
[RouterA] ip route-static 1.1.4.0 255.255.255.0 1.1.6.2
[RouterA] ip route-static 1.1.5.0 255.255.255.0 1.1.2.2
2 Configure the static routes for RouterB:
[RouterB] ip route-static 1.1.5.0 255.255.255.0 1.1.3.1
[RouterB] ip route-static 1.1.1.0 255.255.255.0 1.1.6.1
3 Configure the static routes for RouterC:
[RouterC] ip route-static 1.1.1.0 255.255.255.0 1.1.2.1
[RouterC] ip route-static 1.1.4.0 255.255.255.0 1.1.3.2
The status of the physical interface and link layer protocol is UP, but IP packets
cannot be forwarded normally.
Troubleshooting:
Use the
display ip routing-table static
related static routes are configured correctly or not.
Use the
display ip routing-table
is already effective or not.
Check whether the next hop address is specified or specified correctly on the
NBMA type interface.
Check the secondary routing table of the link layer on the NBMA interface to
see if the configuration is correct.
Host3 1.1.5.1
E0
1.1.5.2
s0 s1
1.1.2.2 1.1.3.1
Router C
s0
s0
1.1.2.1
1.1.3.2
s1 s1
1.1.6.1
1.1.6.2
Router A Router B
command to see whether this static route
E0
1.1.4.1
Host2 1.1.4.2
command to check whether