3Com 3032 Configuration Manual page 54

50 C 3: S
HAPTER YSTEM
View Current and Saved
Configuration of the
Router
View and Select the
Storage Media of
Configuration File
M
ANAGEMENT
226 file transmit success.
ftp: 735 bytes received in 0.06Seconds 12.25Kbytes/sec.
During the power-on of the router, read the configuration files from Flash (or
NVRAM) to initialize the router. Therefore, the configuration file in Flash (or
NVRAM) is called initial configuration. If there is no configuration file in Flash (or
NVRAM), the router will use default parameters for initialization. Corresponding to
initial configuration, the configuration immediately effective during the running
process of the router is called current configuration.
In general, the initial configuration and current configuration should be the same.
In the case of upgrading (such as upgrading the host software version or board),
the initial configuration might be different from the current configuration. Then
you should save the initial configuration in time to avoid the loss of some
configuration commands.
The following commands can be used in all views.
Table 24 View router configuration
Operation
View the initial configuration of the router
View the current configuration of the router
View the current system configuration of the
router
View all the current interface configuration of
the router
View the current IP routing and routing policy
configuration of the router
View all the routing protocol configuration of
the router
View the current IKE proposal configuration of
the router
View the current IPSec policy configuration of
the router
View the current IPSec proposal configuration of
the router
View the current fr-class configuration of the
router
View the current voice configuration of the
router
The the 3Com Router series has two kinds of media, i.e. Flash and NVRAM, to
store configuration files. Either can be selected with the
serve as the storage media of configuration file. The current media can be viewed
by the
display current-configuration
Please use the following commands in corresponding views.
Command
display saved-configuration
display current-configuration
display current-configuration
global
display current-configuration
interface type [ number ]
display current-configuration ip
{ route | route-policy }
display current-configuration
protocol protocol
display current-configuration
ike-proposal
display current-configuration
ipsec-policy
display current-configuration
ipsec-proposal
display current-configuration
fr-class
display current-configuration
voice { aaa | access-number |
acct-method | cdr }
configfile
command.
command to