3Com 3032 Configuration Manual page 394

390 C 25: C
HAPTER ONFIGURING
DLS
W
Table 442 Configure Idle time encoding mode of synchronous Interface
Operation
Configure idle time encoding mode of synchronous
interface
Restore idle time encoding mode of synchronous
interface
By default, the synchronous interface uses encoding mode "7E".
Generally, the idle time encoding mode of synchronous interface doesn't need to
be modified. You may need to configure this command when connecting AS/400,
that is, to change the idle time encoding mode in order to accelerate the polling
rate of AS/400.
16 Configure Parameters of DLSw Timer
The values of various timers used when DLSw established virtual circuits can be
modified by configuring DLSw protocol timer.
Please carry out the following configuration in system view.
Table 443 Configure parameters of DLSw timer
Operation
Configure parameters of DLSw timer
Restore the default value of each
parameter of DLSw timer
By default,
cache seconds
is 30;
seconds local-pending seconds
It is recommended that subscribers do not modify or configure the parameters of
DLSw timers in the common conditions.
17 Configure Other Parameters of LLC2
a Configure LLC2 Local Acknowledgement Delay Time
The message transmitted by SNA over Ethernet is LLC2 message. Some
working parameters of LLC2 can be modified by configuring the commands
related to LLC2.
LLC2 local acknowledgement delay time refers to max wait time of delay
acknowledgement when receiving a piece of LLC2 data message.
Please process the following configurations in the Ethernet interface view.
Table 444 Configure LLC2 local acknowledgement delay time
Operation
Configure LLC2 local acknowledgement delay time
Restore the default value of LLC2 local acknowledgement delay
time
By default, LLC2 local acknowledgement delay time is 100 ms.
b Configure LLC2 Premature Acknowledgement Window
Command
dlsw timer [ cache seconds ] [
connected seconds ] [ keepalive
seconds ] [ local-pending seconds ]
[ remote-pending seconds ]
undo dlsw timer [cache | connected |
keepalive | local-pending |
remote-pending ]
is 120;
connected seconds
is 10;
remote-pending seconds
Command
idle-mark
undo idle-mark
is 300;
keepalive
is 30.
Command
llc2 timer ack-delay
mseconds
undo llc2 timer
ack-delay