3Com 3032 Configuration Manual page 214

210 C 16: C
HAPTER ONFIGURING
LAPB X.25
AND
Table 250 Specify/Cancel packet pre-acknowledgement
Operation
Set packet acknowledgment value
Cancel packet acknowledgment value
By default, the number of pre-acknowledged packets is 0.
4 Configure X.25 user facility
X.25 protocol defines various user facility options. The user can choose and
configure the facilities. These configurations can be modified in two ways:
Configuration based on X.25 interface (use "
command); configuration based on address mapping (use "
command).
The configuration based on X.25 interface will be effective in every call originated
from this X.25 interface, while the configuration based on address mapping will
be effective only in the calls originated from this address mapping.
In the interface view, perform the following task.
Table 251 Configure X.25 user facility
Operation
Specify CUG (Closed User Group)
Cancel CUG number
Perform flow control parameter negotiation
while initiating a call
Cancel flow control parameter negotiation
while initiating a call
Request reverse charging while initiating a
call
Cancel the request of reverse charging
while initiating a call
Command
x25 receive-threshold
packet-count
undo x25 receive-threshold
x25 call-facility.....
x25 map......
Command
x25 call-facility
closed-user-group group-number
Or
x25 map protocol protocol-address
x121-address x.121-address
closed-user-group group_number
undo x25 call-facility
closed-user-group
x25 call-facility packet-size
1
in-size out-size
Or
x25 map protocol protocol-address
x121-address x.121-address
packet-size in-size out-size
x25 call-facility window-size
1
in-size out-size
Or
x25 map protocol protocol-address
x121-address x.121-address
window-size in-size out-size
undo x25 call-facility packet-size
Or
undo x25 call-facility window-size
x25 call-facility
reverse-charge-request
Or
x25 map protocol protocol-address
x121-address x.121-address
reverse-charge-request
undo x25 call-facility
reverse-charge-request
"
"
1
1