3Com 3032 Configuration Manual page 377

Configure IPX
clients can always obtain the latest server addresses. The following diagram
describes the relation between main components of SAP.
Figure 136 Schematic diagram of the relation between main components of SAP
T i m e r
P e r i o d i c
B r o a d c a s t
P r o c e s s
IPX configuration includes:
Activate/deactivate IPX
Enable IPX interface
Adjust Novell IPX delay value
Configure relative parameters of IPX RIP
Configure relative parameters of IPX SAP
Modify length of service information reserve queue
Use trigger refresh
Deactivate horizontal division
Configure IPX packet management
Modify encapsulation format of IPX frame
Configure IPX on WAN
1 Activate/Deactivate IPX
Perform the following task in system view.
Table 406 Activate/deactivate IPX
Operation
Activate IPX
Deactivate IPX
If the node of a router is not specified, then the router will use the MAC address of
its first Ethernet interface as its node address.
2 Enable IPX Interface
After activating the IPX function of a router, each independent interface must be
assigned with a network ID so that IPX can run on the interface.
S e r v e r
I n f o r m a t i o n
T a b l e
S A P P r o c e s s
S o c k e t
S A P R e q u e s t / R e s p o n s e P a c k e t s
0 x 4 5 2
I P X
N I C s a n d D r i v e r s
Command
ipx enable [ node node ]
undo ipx enable
Configure IPX 373
S e r v e r I n f o r m a t i o n
T i m e r
A g i n g
P r o c e s s