3Com 3032 Configuration Manual page 136

132 C 10: C
HAPTER ONFIGURING
WAN I
NTERFACE
Table 127 Enter the synchronous serial interface view
Operation
Enter the synchronous serial interface view
The following are to be set:
Operating parameters of data link layer protocol, such as PPP, Frame Relay,
LAPB or X.25.
IP address
The operating parameters of the standby center need to be set when the
interface serves as the main interface or standby interface of the standby
center.
The rules for address translation or packet filtering need to be set if the firewall
is to be set up on the interface.
For more details, refer to the related sections of this manual.
3 Bind the interface to be channel sets
Perform the following configurations in CE1/PRI interface view.
Table 128 Bind the interface to be channel sets
Operation
Bind the timeslots of CE1/PRI interface to a
channel set
Remove binding timeslots to form channel
sets
The timeslots can be bind to form up to 31 channel sets on a CE1/PRI interface.
The CE1/PRI interface can be bound to be channel sets only when it is enabled to
operate in CE1/PRI mode through the
Only one timeslot binding mode is supported on one CE1/PRI at one time, that is,
the interface can only be bound into either channel sets or a pri set in that period.
After binding the interface to be channel sets, the system will automatically create
a Serial interface numbered serial number:set-number. This interface has the
same logic feature as that of a synchronous serial interface, and can be treated as
a synchronous serial interface for further configurations.
Perform the following configuration in all views.
Table 129 Enter the synchronous serial interface view
Operation
Enter the synchronous serial interface view
The following is to be set:
Operating parameters of data link layer protocol, such as PPP, Frame Relay,
LAPB or X.25.
IP address
The operating parameters of the standby center need to be set when the
interface serves as the main interface or standby interface of the standby
center.
Command
interface serial number:0
Command
channel-set set-number
timeslot-list range
undo channel-set set-number
command.
using ce1
Command
interface serial
number:set-number