3Com 3032 Configuration Manual page 116

112 C 9: C
HAPTER ONFIGURING
LAN I
NTERFACE
Table 85 Enter view of specified Ethernet interface
Operation
Enter view of specified Ethernet interface
2 Set network protocol address
The 3Com Router supports IP and IPX at Ethernet interface. Therefore, it is
necessary to configure IP or IPX network address.
Please use the following commands in Ethernet interface view.
Table 86 Set IP address
Operation
Set IP address
Cancel IP address
When an Ethernet interface is configured with two or more IP addresses, use
keyword "sub" to identify them.
Please use the
ipx enable
Ethernet interface view.
Table 87 Set IPX address
Operation
Specify IPX network node value
Delete IPX network node value.
Specify IPX network number
Delete IPX network number
3 Set frame format of sending message
Both Ethernet_II and Ethernet_SNAP can support IP and IPX. The Ethernet
interface can identify these two formats out of received frame, but can only
choose one frame format for the sent frame.
Please use the following commands in Ethernet interface view.
Table 88 Set frame format of sending message
Operation
Set frame format of sending message
Recover default frame format of sending
message
The frame format of sending message is Ethernet_II by default.
4 Set MTU
Maximum transmission unit (MTU) will influence the fragmentation and
reassembling of network message.
Please use the following commands in Ethernet interface view.
Table 89 Set MTU
Operation
Set MTU
Command
interface ethernet number
Command
ip address ip-address ip-mask [ sub ]
undo ip address ip-address ip-mask [
sub ]
command in system view, and use the
Command
ipx enable [ node node ]
undo ipx enable
ipx network network-number
undo ipx network
Command
send-frame-type { ethernet_ii |
ethernet_snap }
undo send-frame-type
Command
mtu size
in
ipx network