3Com 3032 Configuration Manual page 463

10 Create a filtering policy based on the access list for the peer group
11 Create a BGP route filtering based on the AS path for the peer group
12 Configure the BGP version of peer group
Creating Aggregate
Addresses
Create routing policy for peer group
Remove a routing policy to import or
export routes
By default, the route from the peer or peer group is not designated with any route
policy.
Table 537 Create a Filtering Policy Based on Access List for Peer Group
Operation
Create an filtering policy based on access
list for peer group
Delete an filtering policy based on access
list for peer group
By default, no route filtering policy based on IP ACL for peer group is set.
Table 538 Create a BGP Route Filtering Based on AS Path for Peer Group
Operation
Create a BGP route filtering based on AS
path for peer group
Delete a BGP route filtering based on AS
path for peer group
By default, a BGP filtering is disabled.
Table 539 Configure BGP Version of Peer Group
Operation
Configure the BGP version of peer group
Restore the default BGP version for the
peer group
By default, software accepts BGP Version 4.
CIDR supports manual route aggregation. Manual aggregation, using the
command adds a piece of routing aggregate information to the BGP
aggregate
routing table. The parameters can be set at the same time when manual
aggregation mode is configured.
Perform the following configurations in BGP view.
Table 540 Create an Aggregate Addresses
Operation
Configuring BGP
peer group-name route-policy
policy-name { import | export }
undo peer group-name route-policy
policy-name { import | export }
Command
peer group-name filter-policy
acl-number { import | export }
undo peer group-name filter-policy
acl-number { import | export }
Command
peer group-name acl
aspath-list-number { import | export
}
undo peer group-name acl
aspath-list-number { import | export
}
Command
peer group-name version
version-number
undo peer group-name version
Command
459