Display And Debug - 3Com 3032 Configuration Manual

3com 3032: user guide
Hide thumbs Also See for 3032:
Table of Contents

Advertisement

Display and Debug

LAPB and X.25
Typical LAPB
Configuration
Example
By default, X.25 template is not applied on DLCIs.
In the all views, perform the following tasks to enable real-time monitoring of the
current status of LAPB and X.25.
Table 273 Display and debug LAPB and X.25
Operation
Display interface information
Display X.25 alias table
Display X.25 hunt group information
Display X.25 address mapping table
Display X.25 switching route table
Display X.25 switching virtual circuit table
Display X.25 virtual circuit
Enable X.25 information debugging
Enable X.25 event debugging
Enable X.25 packet debugging
Enable XOT debugging
I. Networking Requirement
Two routers are directly connected via serial ports with LABP protocol to transmit
IP data packets directly.
II. Networking Diagram
Figure 67 Direct connection between two routers via serial ports
III. Configuration Procedure
As shown in the diagram above, perform the following configuration tasks:
1 Configure Router A:
a Select interface
[Router]interface serial 0
b Specify IP address for this interface
[Router-Serial0]ip address 202.38.160.1 255.255.255.0
c Configure the link layer protocol of the interface to LAPB and specify its
working mode as DTE
[Router-Serial0]link-protocol lapb dte
d Configure other Lapb parameters (if the link is of good quality, and a higher
rate is required, the flow control parameter modulo can be increased to 128, k
to 127, but they must be the same for both ends in the direct connection)
Display and Debug LAPB and X.25
Command
display interface [ type number ]
display x25 alias-policy
display x25 hunt-group-info [
hunt-group-name ]
display x25 map
display x25 switch- vc-table svc
display x25 switch-vc-table pvc
display x25 vc lci-number
debugging x25 all [interface
interface-type interface-number ]
debugging x25 event [interface
interface-type interface-number ]
debugging x25 packet [interface
interface-type interface-number ]
debugging x25 xot
V.35 cable
Serial 0
Serial 1
Router A
Router B
223

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

303430333035304030413036 ... Show all

Table of Contents