Pim-Dm Configuration Example - 3Com 3032 Configuration Manual

514 C 35: C
HAPTER ONFIGURING
PIM-DM Configuration
Example
PIM-DM
Turn on the switch of PIM-DM debugging
information
After making the previous configuration, execute the
views to display the running of the PIM-DM configuration, and to verify the effect
of the configuration. Execute the
PIM-DM.
In this example, the multicast source server is the multicast source, while RECEIVER
1 and RECEIVER 2 are the two receivers of this multicast group.
Figure 163 PIM-DM configuration and networking
Router
Multicast
source
1 Enable multicast routing protocol
[Router] multicast routing-enable
2 Enable PIM-DM protocol
[Router] interface Ethernet 0
[Router-Ethernet0] pim dm
[Router-Ethernet0] interface serial 0
[Router-Serial0] pim dm
[Router-Serial0] interface serial 1
[Router-Serial1] pim dm
debugging pim dm { alert | all | mrt
| timer | warning | { recv | send } {
all | assert | graft | graft-ack |
join | prune } }
display
command in system view to debug
debugging
Router
RECEIVER 1
Router
RECEIVER 2
command in all