3Com 3032 Configuration Manual page 680

676 C 48: T
HAPTER RAFFIC
Displaying and
Debugging Traffic
Shaping
GTS Configuration
Example
P , T S
OLICING RAFFIC HAPING AND
Table 714 Configure Shaping Parameters for a Specified Flow
Operation
Configure the shaping parameters for a
specified flow
Cancel shaping parameters for a specified
flow
By default, the traffic shaping is not performed on the interface.
This command may be repeatedly used to set different shaping parameters for
different flows.
This command cannot be used together with the
same interface.
Configuring shaping parameters for all flows
Shaping all the flows means shaping all the flows passing this interface.
Please perform the following settings in the interface view.
Table 715 Configure Shaping Parameters for all Flows
Operation
Configure shaping parameters for all
flows
Cancel the shaping parameters of the flow undo qos gts any
By default, the traffic shaping is not performed on the interface.
This command cannot be used along with the qos gts acl command on the same
interface. You must disable fast forwarding before configuring all the traffic
shaping parameters.
Table 716 Display and Debug Traffic Shaping
Operation
Display the GTS configuration conditions
and statistic information of the interface
1 Configure the ACL.
[Router]acl 110
[Router-acl-110] rule permit udp source any destination any
Shape the flows matching 110 on Ethernet interface 0.
[Router-acl-110] interface ethernet0
[Router-Ethernet0] qos gts acl 110 cir 2000000 cbs 120000 ebs 120000
L R
INE ATE
Command
qos gts acl acl-index cir
committed-rate [ cbs burst-size [ ebs
excess-burst-size [ queue-length
queue-length ] ] ]
undo qos gts acl acl-index
Command
qos gts any cir committed-rate [ cbs
burst-size [ ebs excess-burst-size [
queue-length queue-length ] ] ]
Command
display qos gts [ interface type
number ]
command in the
qos gts any