3Com 3032 Configuration Manual page 370

366 C 23: C
HAPTER ONFIGURING
IP Count
Configuration
IP C
OUNT
Figure 134 Networking for an IP Count application
169.254.10.1
PC1
A
IP Count mainly implements the following functions:
Configure IP Count list
Make statistics on the output and input packets
Make statistics on the packets processed by the firewall
Display all packet statistics
Clear all packet statistics
Basic Configuration includes:
Enable IP Count Service
Enable IP Count on an interface
Advanced Configuration includes:
Configure IP Count list
Configure upper threshold for accounting entries in Interior-List
Configure upper threshold for accounting entries in Exterior-List
Configure timeout time of IP Count statistics list entries
1 Enable IP Count Service
This command can be used to enable or disable IP Count service. You can
configure IP Count to make statistics on the packets that the router has input or
output depending on the specific requirements on the router.
Perform the following configuration in system view.
Table 399 Enable/Disable IP Count service
Operation
Enable IP Count
Disable IP Count
By default, IP Count is not enabled.
2 Configure IP Count on an Interface
E0:
Router
169.254.10.1
PC2
Command
ip count enable
undo ip count enable
PC3
E1
PC4
B