3Com 3032 Configuration Manual page 419

Enabling RIP
Enabling RIP at the
Specified Network
Configuring RIP Horizontal Segmentation on the Interface
Configuring Route Import for RIP
Specifying Default Route Metric Value for RIP
Specifying Additional Route Metric Values for RIP
Setting Route Preference
Configuring Route Distribution for RIP
Resetting RIP
To enter RIP view, you must first enable RIP, then configure the parameters related
to the RIP protocol. Interface-related parameters are not subject to enabling of RIP.
Perform the following configurations in system view.
Table 469 Enabling RIP
Operation
Enable RIP and enter the RIP view
Disable RIP
By default, RIP is not enabled.
The parameters related to an interface are also invalid after RIP is turned off.
To flexibly control RIP operation, you can configure a corresponding network
segment to RIP network so that RIP messages can be received and transmitted
through the specified interface.
Perform the following configurations in RIP view.
Table 470 Enable RIP at the Specified Network
Operation
Specify a list of networks associated with
RIP
Delete a list of networks associated with
RIP
The command is associated with RIP by default after RIP is enabled.
undo network
After enabling RIP, you must specify a list of networks with the RIP, since RIP works
only on the interface of specified network segment. RIP won't receive or forward a
route on interfaces of non-specified network segments, and it functions as if these
interfaces do not exist. The
enabled or disabled network or it can designate the network address of the
interfaces.
When the command is used for a specified address, the interface of the
network
network segment of this address is enabled. For example:
use either the
display current-configuration
to see network 129.102.0.0.
Command
rip
undo rip
Command
network { network-number | all }
undo network { network-number | all }
attribute specifies the address of the
network-number
or the
Configure RIP 415
network 129.102.1.1
command,
display rip
,