Configuration Procedure - 3Com 3032 Configuration Manual

312 C 19: C
HAPTER ONFIGURING
Bridge-Template
interface
B
RIDGE
I. Networking Requirements
Configure a router so that routing can be carried out on each interface in the
bridge-set.
II. Networking Diagram
Figure 114 Networking of bridge-template interface
III. Configuration Procedure
[Router]bridge enable
[Router]bridge routing-enable
[Router]bridge 1 stp ieee
[Router]interface ethernet1
[Router-Ethernet1]bridge-set 1
[Router-Ethernet1]interface ethernet2
[Router-Ethernet2]bridge-set 1
[Router-Ethernet2]interface bridge-template 1
[Router-Bridge-Template1]ip address 1.1.1.1 255.255.0.0
[Router-Bridge-Template1]interface ethernet0
[Router-Ethernet0]ip address 2.1.1.1 255.255.0.0
Bridge-Template
interface 1.1.1.1
Bridge Set 1
E1
E0
2.1.1.1
E2
Router