3Com 3032 Configuration Manual page 488

484 C 31: C
HAPTER ONFIGURING
IP R P
OUTING OLICY
Table 563 Configure Route Import
Operation
Configure route import in RIP
Cancel route import
Configure route import in OSPF
Cancel route import
Configure route import in BGP
Cancel route import
By default, a protocol does not import routes from other domains into the its
routing table.
specifies the source routing domain that can be imported. At present, it
protocol
can import routes domain such as direct, static, RIP, OSPF, OSPF-ASE and BGP.
Software supports importing route information found by the ollowing protocols
into the route table:
direct: network segment (or host) route directly connected to the router's
interface
static: static route
RIP: routes discovered by rip
OSPF: routes discovered by ospf
OSPF-ASE: external routes discovered by ospf
BGP: routes discovered by bgp
or
med med cost cost:
bandwidth is the route bandwidth, ranging from 1 to 4294967295 kbyte/s.
delay is the route time delay, each unit stands for 10µs, ranging from 1 to
16777215
reliability is the channel reliability, ranging 0 to 255. 255 stands for 100%
creditable.
loading is the channel seizure rate, ranging 1 to 255, 255 stands for 100% seized.
mtu is the maximum transfer unit of route, ranging from 1 to 65535 byte.
route-policy policy-name
specified routing policy name. This item can be used in the routing protocol
configuration except in the OSPF view.
sets the tag value of the imported route when ospf is importing
tag tag-value
other protocol routes.
Command
import-route protocol [ cost cost ] [
route-policy route-policy-name ]
undo import-route protocol
import-route protocol [ cost cost ] [
type 1 | 2 ] [ tag tag-value ]
undo import-route protocol [ cost
cost ] [ type 1 | 2 ] [ tag tag-value
]
import-route protocol [ med med ] [
tag tag-value ] [ type 1 | 2 ] [
route-policy policy-name ]
undo import-route protocol
specifies the metric value of the imported routes.
specifies imported routes which matches the