Electrical Connections - MICRO-EPSILON colorSENSOR CFO Series Operating Instructions Manual

Installation and Assembly
4.4
The cable shields are connected to the connector housings. The connector housings are in contact with the
controller housing.
Perform all electrical connections only in the switched-off state.
CAUTION
> Risk of injury from high voltage
1
3
Fig. 10 Connector location on
colorSENSOR CFO200
1 SYS = System (Power/PLC)
2 ETH = Ethernet
3 I/O = Digital I/O (PLC), CFO200 only
4 USB, CFO200 only
The widely used and standardized M12 sockets allow the use of commercially available cables suitable for
the special requirements of the respective operating environment. For example, cables are available which
are oil-resistant or suitable for use with drag chains.
colorSENSOR CFO

Electrical Connections

2
4
Fig. 11 Electrical connections on
colorSENSOR CFO200
Power supply, switching outputs, switching input, RS232
Connection to PC
Switching inputs and outputs
USB process interface (RS232 log)
Page 28