MICRO-EPSILON colorSENSOR CFO Series Operating Instructions Manual page 123

Operation
Ethernet set-
tings IPv6
The Ethernet interface is not only used for parameter setting of the measuring system via the web pages or
Fields with gray
via the API command
background re-
The color values for measured value capture are transferred for one subsequent analysis without direct pro-
quire a selection.
cess control. Data transmission takes place at a maximum of 15 Hz.
When using a static IP address it is necessary to enter the values for the IP address, Gateway and Subnet
Fields with dark
Val-
border require
mask; this is not required when DHCP is used. The changed IP settings are active immediately and it may be
ue
entry of a value.
necessary to enter the new IP address in the browser to access the web interface again.
colorSENSOR CFO
Method Automatic
Dynamic
(DHCP)
Static
MAC address
set, see A 3, but also enables non-real-time data transfer (packet-based data transfer).
Using Stateless Address Autoconfiguration
(SLAAC, specified in RFC 4862), a host
can establish a functional Internet connec-
tion fully automatically. To do this, it com-
municates with the routers responsible
for its network segment to determine the
necessary
DHCP Value When DHCP is activated, the controller is
Host name accessible in the network under its DHCP
Host name. With DHCP it may be neces-
sary to enable the controller MAC address.
IP address Value When using a static IPv6 address, the
values for IP address, prefix length, and
gateway must be specified; this is omitted
when using DHCP or Automatic.
Prefix length Value
Value see DHCP
configuration, see Fig. 70.
Page 123