Manual Intensity Control - MICRO-EPSILON colorSENSOR CFO Series Operating Instructions Manual

Operation
5.3.3.2
Typically, the automatic modulation determines a suitable combination of LED intensity, amplification, mea-
surement averaging and other internal parameters, depending on the measurement frequency. If a higher
modulation is desired, perform the following steps in the intensity menu.
colorSENSOR CFO

Manual Intensity Control

If a lower modulation is desired, press the
INT
TEACH
AUTO i
CLR OPT
GATE 1
TEACH 2
HOLD 3
ESC
MULTI 4
TOL
CLASSIFY 5
6
SPHERE
CYLINDER 7
BOX 8
After the new modulation is completed, the level of control achieved can be seen
from the output LEDs.
TEACH INT
AUTO
CLR OPT
GATE 1
TEACH 2
HOLD 3
ESC
MULTI 4
TOL
5
CLASSIFY
SPHERE 6
CYLINDER 7
BOX 8
Press the key for less than 2 sec.
The photo receiver modulation can be increased or decreased by 10% by
pressing the corresponding arrow key.
key for less than 2 sec.
Page 48