MICRO-EPSILON colorSENSOR CFO Series Operating Instructions Manual page 121

Operation
Assign a static IP address or activate DHCP .
When DHCP is activated, the controller is accessible in the network under its DHCP Host name. The DHCP
host name must be at least one and at most 63 characters long and may only contain alphanumeric charac-
ters (a-z, A-Z, 0-9, no umlauts) and the special character -.
With DHCP it may be necessary to enable the controller MAC address in the network.
Ethernet set-
tings IPv4
Fields with gray
With IPv4, approx. 4.3 billion different addresses can be generated. With IPv6, approx. 340 sextillion address-
background re-
es can be assigned. IPv6 has been considered the successor to IPv4 since 1998.
quire a selection.
An IPv6 address is 128 bits long (IPv4: 32 bits). The first 64 bits form the so-called prefix, the last 64 bits con-
sist of a unique interface identifier. The IPv6 address usually consists of 32 hexadecimal digits. The address
Fields with dark
Val-
from
border require
ue
entry of a value.
0000 are abbreviated by ::), means written out fe80:0000:0000:020c:12ff:fe02:10a5.
colorSENSOR CFO
Go to the Apply button to apply the settings you have made.
Method Static
Dynamic
(DHCP)
MAC address
Go to the menu Settings > System settings > Ethernet settings IPv4.
example, see Fig. 71, fe80::20c:12ff:fe02:10a5 (leading zeros within a block are omitted; consecutive
IP address Value
Subnet mask Value
Gateway Value
DHCP Value
Host name
Value
When using a static IP ad-
dress it is necessary to enter
the values for the IP address,
Gateway and Subnet mask;
this is not required when
DHCP is used.
When DHCP is activated, the
controller is accessible in the
network under its DHCP Host
name.
With DHCP it may be neces-
sary to enable the controller
MAC address in the network.
Page 121