Disclaimer; Service, Repair - MICRO-EPSILON colorSENSOR CFO Series Operating Instructions Manual

Disclaimer

7.
All components of the device have been checked and tested for functionality in the factory. However, should
any defects occur despite careful quality control, these shall be reported immediately to MICRO-EPSILON or
to your distributor / retailer.
MICRO-EPSILON undertakes no liability whatsoever for damage, loss or costs caused by or related in any
way to the product, in particular consequential damage, e.g., due to
- non-observance of these instructions/this manual,
- improper use or improper handling (in particular due to improper installation, commissioning, operation
- repairs or modifications by third parties,
- the use of force or other handling by unqualified persons.
This limitation of liability also applies to defects resulting from normal wear and tear (e.g., to wearing parts)
and in the event of non-compliance with the specified maintenance intervals (if applicable).
MICRO-EPSILON is exclusively responsible for repairs. It is not permitted to make unauthorized structural
and / or technical modifications or alterations to the product. In the interest of further development, MICRO-
EPSILON reserves the right to modify the design.
In addition, the General Terms of Business of MICRO-EPSILON shall apply, which can be accessed under
Legal details | Micro-Epsilon https://www.micro-epsilon.com/impressum/.
8.
If the controller or the sensor are defective, please
send in the affected parts for repair or replacement.
If the cause of a fault cannot be clearly identified,
please send the entire test system to:
colorSENSOR CFO
Disclaimer
and maintenance) of the product,

Service, Repair

MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Deutschland
Tel: +49 (0) 7161 / 98872-300
Fax: +49 (0) 7161 / 98872-303
eltrotec@micro-epsilon.de
www.micro-epsilon.de
Page 136