4: Installation; Unpacking - Labconco Cell Logic+ B2 User Manual

4: Installation

With the installation site properly prepared, you are ready to unpack and install the
equipment. This section covers how to:
• Unpack and move the product
• Install the product
• Connect electrical service
• Connect service utilities
• Connect to an exhaust system (optional)
• Arrange certification for the product
• Install the microscope (optional with Scope-Ready package only)
• Install the circulator (optional with the Temp-Zone package only)
A quick reference Installation Guide is located on the front sash glass (see Figure 4-2)

Unpacking

The following tools are required to unpack the equipment:
• Box knife
• #2 Phillips screwdriver
• Two ½" wrenches
• Pliers
• Carpenter's level
The following safety precautions must be followed by all personnel unpacking the
equipment.
• Wear safety glasses and gloves
• No loose fitting clothes
• Wear close-toed shoes
• Follow safe-lifting practices (do NOT attempt to lift this product without
specialized lifting equipment certified to lift up to 1000 lbs.)
22