Omron VARISPEED L7 Manual page 219

Step
No.
Press the Increment and Decrement Key until parameter o3-01 is displayed (Copy Function
3
Selection).
4 Press the DATA/ENTER Key and select the constants setting display.
5 Change the set value to 2 using the Increment Key.
6 Set the changed data using the DATA/ENTER Key. The COPY function starts.
7 If the COPY function ends normally, "End" is displayed on the Digital Operator.
8 The display returns to o3-01 when a key is pressed.
6 If an error is displayed, set the parameters again. Refer to
for corrective actions.
68
6-
Explanation
page 7-16, Digital Operator Copy Function Faults
Digital Operator Display
-ADV-
COPY Function
o3 - 01 = 0
Copy Funtion Sel
-ADV-
Copy Function Sel
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Function Sel
o3-01= 2
*0*
OP INV WRITE
-ADV-
COPY
OP INV COPYING
-ADV-
COPY
COPY COMPLETE
-ADV-
Copy Function Sel
o3 -
01 =0
*0*
COPY SELECT