LED Monitor JVOP-163
LED Monitor
The LED monitor indicates the operation status by combinations of the LED display (Lights up, Blink, and
Off) at RUN, DS1, and DS2.
The LED pattern is as follows at each mode.
3
LED Display Examples
Normal operation: The figure below shows the LED display when the drive is ready and no FWD/REV
Alarm: The figure below shows an example of the LED display when a minor fault occurs.
Refer to Chapter 6 and take appropriate countermeasures.
Fault:
The figure below shows an example of the LED display when an OV or UV fault has
occurred
2
3-
Fig 3.1 Digital Operator Component Names and Functions
signal is active
RUN
DS1
DS2
RUN
DS1
DS2
RUN
DS1
DS2
Operation Mode Indicators
RUN: Lights up during inverter run, Off if the inverter is
stopped
DS1:
Drive Status 1
DS2:
Drive Status 2
The combination of the three LEDs Run, DS1 and DS2
indicates the drive status.
Drive Status Indications
Alarm Indications
Fault Indications
POWER
POWER
POWER