Omron VARISPEED L7 Manual page 220

Comparing Inverter Parameters and Digital Operator Parameter Set Values (VERIFY)
To compare Inverter parameters and Digital Operator parameter set values, use the following method.
Step
No.
1 Press the MENU Key and select advanced programming mode.
2 Press the DATA/ENTER Key.
Press the Increment and Decrement Key until the parameter o3-01 is displayed (Copy Func-
3
tion Selection).
4 Press the DATA/ENTER Key and select the function setting display.
5 Change the set value to 3 using the Increment Key.
6 Set the changed data using the DATA/ENTER Key. The VERIFY function starts.
7 If the VERIFY function ends normally, "End" is displayed on the Digital Operator.
8 The display returns to o3-01 when a key is pressed.
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Refer to
page 7-16, Digital Operator Copy Function Faults
Application Precautions
When using the copy function, check that the following settings are the same between the Inverter data and the
Digital
• Inverter product and type
INFO
• Software number
• Inverter capacity and voltage class
• Control method
Explanation
for corrective actions.
Digital Operator Display
-ADV-
** Main Menu **
Programming
-ADV-
Initialization
A1 - 00 = 1
Select Language
-ADV-
COPY Function
o3 - 01=0
Copy Funtion Sel
-ADV-
Copy Function Sel
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Funtion Sel
o3-01= 3
*0*
OP INV VERIFY
-ADV-
VERIFY
DATA VERIFYING
-ADV-
VERIFY
VERIFY COMPLETE
-ADV-
Copy Function Sel
o3 -
01 = 0
*0*
COPY SELECT
6
69
6-