Electrical installation
Contents of this chapter
This chapter describes how to:
•
measure the insulation
•
do the grounding system compatibility check
•
change the EMC filter connection
•
connect the power and control cables
•
install optional modules
•
connect a PC.
Required tools
To do the electrical installation, you need the following tools:
•
wire stripper
•
screwdriver or wrench with a set of suitable bits. For motor cable terminals,
the recommended screwdriver shaft length is 150 mm (5.9 in).
•
short flat head screwdriver for the I/O terminals
•
torque wrench
•
multimeter and voltage detector
•
personal protective equipment.
Electrical installation 61
6