Table of Contents
Advertisement
Safety
► Activate the wheel lock each time before you get into or out of or transfer to or from the wheelchair.
► Never step on the foot plates when getting in and out.
► When getting into/out of the wheelchair, do not support yourself on the wheel lock.
► Prior to activities that require bending forward in the seat (e.g. getting in, tying shoes), maximise the stability of
the product. In order to do so, push the product backwards until the caster wheels turn forward.
► The user must not lean too far out of the seat when reaching for objects.
► The product includes moveable components that can pinch and crush the user (e.g. seat tilt, back support
angle adjustment, leg supports, wheel locks). Do not reach between the moveable components.
► Please note that diagnostic examinations and therapeutic treatment with medical devices may result in improper
interactions between your product and the devices used. Examinations and treatments must be carried out
exclusively under the prescribed conditions.
► Do not expose the product to any extreme temperatures (e.g. prolonged direct sunlight, sauna, close proximity
to heating appliances, prolonged extreme cold).
► Note that, in extreme temperatures, hypothermia or burns may occur in case of unprotected contact with com
ponents.
► Check your skin for intactness where it is in contact with the product before and during use of the product.
► Note that excessive strain on the skin may result in skin damage or pressure points. Pay attention to diligent
skin care and pressure redistribution. If skin damage occurs, stop using the product and consult qualified per
sonnel.
► In case of damage, have the seat cushions, pads and covers replaced immediately.
► Note that dirt, salt and sand may damage the wheelchair components (e.g. bearings, joints). Always clean
them promptly and observe the maintenance and care instructions.
4.2.2 Safety notices for driving
General:
•
Practise on level, open ground first.
•
Learn with the support of an assistant how the product reacts to changes in centre of gravity, e.g. downward or
upward slopes, inclines or when overcoming obstacles.
•
Always step into the product from the side if possible.
•
Do not reach between the drive wheel and wheel lock or drive wheel and side panel when driving the wheel
chair.
•
Do not reach into the spokes of the rotating drive wheels.
•
Note that heat generated when braking with hand Rims can cause burns due to insufficient protection of
hands. Wear wheelchair gloves when travelling at high speeds.
•
Adapt your speed to the conditions and reduce it accordingly in danger areas, on downgrades and when
crossing obstacles. Typical hazards and obstacles are:
–
narrow paths along waterways, slopes, precipices (e.g. quay walls, embankments etc.),
–
confined spaces or areas,
–
steps, curbs
–
steep downgrades (e.g. in the mountains, towards roads),
–
unpaved terrain (construction sites, crossings, level crossings),
–
snow-covered paths.
•
Only manoeuvre backwards over short distances and on even surfaces.
•
Wear light-coloured clothing or clothing with reflectors when driving in the dark. Install active lighting on your
product. Ensure that the reflectors on the product are clearly visible.
•
When using public transit, always observe the currently applicable legal requirements and the safety notices of
the public transit operator.
•
Use the permanently installed seats in the vehicle. If you need to use your wheelchair as a seat, please use the
designated wheelchair spaces and safety securing equipment provided. Always ensure that you are held in
place securely.
•
The wheelchairs in this series comply with the minimum technical requirements for wheelchairs transportable
by train. Please note that it is possible that not every individual wheelchair will meet the minimum requirements
due to the variation in designs (please see see page 53 for further details).
10
Start Multi
Advertisement
Table of Contents
