Adjusting The Leg Supports - Otto Bock Skippi Instructions For Use Manual

Settings
4
5

6.3.4 Adjusting the leg supports

CAUTION
Improper adjustment of the leg supports and foot plates
Risk of injuries due to uncontrolled driving characteristics, damage to the product
► Make sure that the clearance between the foot plates and ground is sufficient even under load.
► Make sure that the leg supports and foot plates do not come into contact with the caster wheels under load.
The legrests can be subsequently adjusted to the requirements of the user.
6
12
Adapting the control panel position to the forearm
length
1) Loosen the three set screws on the bottom of the
forearm support.
2) Slide the rail with the control panel forwards or
backwards.
INFORMATION: If the control panel rail is too
long, it can be shortened. Please contact the
qualified personnel who adjusted your product.
3) Tighten the three set screws on the bottom of the
forearm support.
Adjusting the height of the control panel position
1) Loosen the set screw on the height adjustment (see
fig. 5, item 1).
2) Adjust the height.
3) Tighten the set screw on the height adjustment.
Longitudinal adjustment of the footrest receiver
Telescoping the footrest receivers in the longitudinal
direction is possible in pairs:
1) Remove the seat cushion, legrests and side panels.
2) Loosen the Allen head screws on both sides of the
seat frame (see fig. 6).
3) Adjust the depth of the footrest receivers to the
desired position.
4) Firmly re-tighten the Allen head screws on both
sides of the seat frame.
5) Put on the seat cushion, and reinstall the legrests
and the side panels.
Skippi