Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
4.5.6 RCCMD Tab Page
The UPS2000 SNMP card integrates the functions of Generex RCCMD Server:
●
●
For a parallel system, select the ESN of the UPS into which the SNMP card is
inserted every time the SNMP card is powered on. Ensure that the entered ESN is
consistent with the ESN of the UPS into which the SNMP card is inserted.
Otherwise, the client cannot receive the correct shutdown command or event
message. For the ESN of the UPS, see the manual delivered with the UPS.
ESN Configuration
If a single UPS is online, the ESN of the UPS is displayed by default and cannot be
set, as shown in
the ESN is empty during first login. Select the ESN of the UPS where the SNMP
card is inserted. If the system experiences a power failure and restarts, the value
set last time is displayed by default.
Figure 4-27 ESN Configuration
RCCMD Tab Page
The RCCMD Shutdown is set to Disabled by default, as shown in
required, set it to Enabled upon first login. After you submit the setting, the page
refreshes. The controls such as SSL Encrypted Transmission and Event
Configuration will be displayed on the page, as shown in
Issue 10 (2024-01-30)
NO TE
● SNMP Trap is used to report alarms and collected data to the NMS and deliver
parameter settings.
● If you use the Huawei NMS software, the Trap port must be set to 162.
Sends the shutdown command, notification message, and Trap message to
the RCCMD client if the UPS system generates an alarm; executes commands
on the RCCMD client.
Configures and saves the address and port for receiving the shutdown
command, and the message sending mechanism.
NO TICE
Figure
4-27. If the SNMP card is inserted into a parallel system,
NO TE
If the UPS system where the SNMP card is inserted is changed, and the ESN set previously
does not exist in the new system, the ESN is empty by default.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Managing the UPS on the WebUI
Figure
Figure
4-29.
4-28. If
38
Advertisement
Table of Contents
