Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
Figure 3-2 Inserting the SNMP card into the optional card slot
Step 3 (Optional) If there is a T/H sensor, insert the RJ11 connector of the T/H sensor
cable into the T/H sensor TEM_HUM port on the SNMP card. For details about
how to install the other end of the cable, see the T/H sensor user manual.
Step 4 Connect one end of the network cable to the network port of the SNMP card and
the other end to the Ethernet port. If the green indicator turns on and the yellow
indicator blinks, the SNMP card is successfully installed and properly
communicating.
----End
3.4 Setting an IP Address for the SNMP Card on the
UPS Control Panel
The default settings of the SNMP card are as follows:
●
●
●
After the SNMP card is installed, you can set the SNMP card IP address on the LCD
of the UPS2000-G. The control panel of the UPS2000-A does not support settings
of monitoring parameters for the SNMP card. Set the parameters on the WebUI.
For details, see
Issue 10 (2024-01-30)
NO TE
M3 screws are used to install the optional card. The recommended torque is 0.5 N·m.
IP address: 192.168.0.10
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
NO TE
Modify the settings based on the network segment that the UPS belongs to.
4.5.1 Comm. Config Tab
Copyright © Huawei Digital Power Technologies Co., Ltd.
3 Installation and Basic Settings
Page.
8
Advertisement
Table of Contents
