Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
Figure 4-11 Comm. Config tab page
Sender's Email Settings
Enter the email server IP address in use, add the sender's email address, set the
SMTP port, enable User secure connection (TLS encryption), and select User
account authentication required when sending a mail. If Yes is selected, enter
the user name and password, and then click Submit. When an alarm is generated,
the alarm information will be sent to the receivers' email addresses. You can click
Delete to delete the sender email address.
Alarm Notification Settings
In the Alarm Notification Settings area, you can select whether to receive email
notifications, SMS notifications (SMS modem required), timely reminder, and
alarm severities (critical, major, minor, and all), as shown in
Information such as the user name, email notification address, and SMS
notification mobile number can be configured on the User Mgmt. tab page.
If you enable alarm notification by email or SMS, when there is an alarm, the
system will send emails or short messages to the receiver at 8:00, 12:00, 16:00,
and 20:00. If the SNMP card is powered on within one hour after 8:00, 12:00,
16:00, or 20:00, the system will check whether the alarm notification has been
Issue 10 (2024-01-30)
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Managing the UPS on the WebUI
Figure
4-11.
27
Advertisement
Table of Contents
