Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
4
4.1 Introduction to the WebUI
The user interface (UI) snapshots in this document correspond to the software
version UPS2000 V200R001C91B082. The UI snapshots are subject to change
without notice. Contact Huawei technical support to obtain the latest snapshots if
necessary.
●
●
●
Issue 10 (2024-01-30)
Managing the UPS on the WebUI
NO TICE
Monitoring page
–
View the active alarm status of the UPS on the Active alarms tab page.
–
View the real-time running data of UPS modules on the Real-Time Data
tab page.
–
Set temperature and humidity alarm parameters of the UPS on the
Param. Settings tab page.
–
Start or shut down the UPS on the Control tab page.
Query page
–
The Logs tab page provides the query function. You can query user
operation information to trace recent operations.
–
The Performance Data tab page displays the UPS performance data. You
can query and export the performance data of the selected UPS.
–
The Historical Alarms tab page displays UPS alarms. You can query and
export the historical alarms of the selected UPS.
Configuration page
–
On the Comm. Config tab page, you can configure the IP address of the
SNMP card, NAT mapping, sender's email settings, alarm notification
settings, and RMS-RELAY02B information configuration.
–
The User Mgmt tab page allows you to create, change, and delete users.
–
On the Site Config tab page, you can configure system parameters,
change the system date, time, and time zone, enable or disable
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Managing the UPS on the WebUI
17
Advertisement
Table of Contents
