Snmp Tab Page - Huawei RMS-SNMP01A User Manual

RMS-SNMP01A SNMP Card
User Manual

4.5.5 SNMP Tab Page

On the SNMP tab page, you can configure the SNMP version, port,
SNMPv1&SNMPv2c read and write communities, SNMPv3 user, NMS address and
access permission, and SNMP Trap, as shown in
Figure 4-21 SNMP tab page
On the SNMP tab page, you can set the SNMP version, port, SNMPv1&SNMPv2c
read and write communities, and SNMPv3 user, as shown in
Figure
If you need to manage the UPS using the NMS, pay attention to this section.
The SNMP version has three options: SNMPv3, SNMPv1&SNMPv2c, and ALL.
Different versions support different NMS access mechanisms.
●
●
●
Issue 10 (2024-01-30)
4-23.
NO TICE
The SNMPv3 is the default option. The NMS can access the SNMP card only
using the configured user name, authentication protocol (MD5/SHA), and
proprietary protocol (DES/AES).
user.
If you select SNMPv1&SNMPv2c, specify the read and write communities. If
this option is selected, the NMS needs to connect to the SNMP card through
the read and write communities set here. When setting the read and write
communities for the first time, you can directly enter them, as shown in
Figure 4-23. If the read and write communities have been entered before,
select Modify SNMP community to modify them, as shown in
If you select ALL, the NMS can connect to the SNMP card by using either of
the preceding methods. For the three options, you need to add the NMS
information in the NMS address and access permission configuration.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Managing the UPS on the WebUI
Figure 4-21.
Figure 4-22 shows how to add an SNMPv3
Figure 4-22 and
Figure 4-24.
34