Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
Performance Data, SNMP, or RCCMD tab pages. You can configure settings in
different tab pages.
You can configure the system IP settings, sender's email settings, alarm
notification settings, and RMS-RELAY02B settings.
System IP Settings
In the System IP Settings area, you can change the SNMP card IP address and
click Submit, as shown in
the new IP address.
If the UPS monitoring module does not support the DHCP function, the SNMP
card IP address cannot be manually set on the UPS monitoring module after
DHCP is selected for the SNMP card. You are advised to upgrade the UPS
monitoring module.
On the WebUI, the MAC address of the SNMP card can be displayed. You can
select DHCP and click Submit to apply for a dynamic IP address to the DHCP
server. After that, log in to the WebUI using the newly applied IP address. If you
select When the IP address is automatically assigned, send an email, the SNMP
card will send an email to you to notify the IP address change.
The NAT uses a few public IP addresses to represent a large number of private IP
addresses so that the SNMP card in the internal network can be accessed through
the external network. This function is disabled by default. If this function is
enabled, you can access the SNMP card in the internal network through the
external network by using a router with the NAT function.
Issue 10 (2024-01-30)
Figure 4-11
NO TICE
NO TE
● You are advised to select When the IP address is automatically assigned, send an
email.
● If DHCP fails to be allocated, the IP address of the SNMP card will restore to the default
IP address 192.168.0.10 and the DHCP will be deselected.
● If the DHCP is selected and the IP address expires during SNMP card power-off, the IP
address will be reallocated after the SNMP card starts.
● If the DHCP is selected and DHCP fails to be allocated after the SNMP card restarts, the
IP address of the SNMP card will restore to the default IP address 192.168.0.10.
Copyright © Huawei Digital Power Technologies Co., Ltd.
shows the Comm. Config tab page.
Figure
4-11. After the change, log in to the WebUI with
4 Managing the UPS on the WebUI
26
Advertisement
Table of Contents
