Table of Contents
Advertisement
RMS-SNMP01A SNMP Card
User Manual
When you add a job, five sending methods are available. The latter three methods
can take effect only when the event condition is still true after the specified
seconds elapse.
●
●
●
●
●
Issue 10 (2024-01-30)
Signal Name
#OUTLOAD
#BATTCAP
#INVOLT
#BYPASSINVOLT
#TEMPDEG
#AUTONOMTIME
#STATUS
#RUNTIME
#BATTVOLT
#INFREQ
#BYPASSINFREQ
#OUTFREQ
#CNT_PF
#CNT_BL
#INPHASES
#OUTPHASES
Immediately, once: After the event happens, the job will be sent to the
RCCMD client immediately.
Scheduled in X seconds: After the event happens, the job will be sent to the
RCCMD client once in X seconds. No matter whether the event disappears or
not within X seconds, the job will be sent.
After X seconds, repeat all Y seconds: After the event happens, the job will be
sent once in X seconds, and then be sent once every Y seconds.
After X seconds on Battery: After the battery mode is activated for X seconds,
the job will be sent to the RCCMD client once.
At X seconds remaining time: When the battery backup time has only X
seconds left, the job will be sent to the RCCMD client once.
NO TE
X and Y are variables and stand for time.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Managing the UPS on the WebUI
Description
Output load rate
Remaining battery
capacity
Input voltage
Bypass input voltage
Temperature inside the
UPS
Battery backup time
UPS status
System runtime
Battery voltage
input frequency
Bypass input frequency
Output frequency
Power supply failure
times
Low battery voltage
times
Number of input phases
Number of output phases
Unit in the UPS
%
%
V
V
Celsius
minutes
-
minutes
V
Hz
Hz
Hz
-
-
-
-
45
Advertisement
Table of Contents
