Table of Contents
Advertisement
DRYPOINT
®
RA III
7.2.4
Remote START-STOP, digital input signal
Illustration
7.2.5
Remote management, Modbus RTU data signal
INFORMATION
Connection work
Modbus RTU installation and configuration
For further information on the Modbus RTU installation and configuration, refer to
the section "1.3 Other applicable documents" on page 7.
Original installa�on and opera�on manual
Description / explanation
1. Guide a two-wires signal cable through
the arranged rubber grommet on the
product.
2. Product side: Connect the cable to the
connector M11 REMOTE/GND of
Electronic Control Unit.
3. Plant side: connect the cable to the
supervisory system of the plant.
4. Make sure that power cable is free of
mechanical stress and mechanically
protected.
65 | 118
Advertisement
Table of Contents
