Beko DRYPOINTRA III 20 Translation Of Original Installation And Operation Manual page 109

DRYPOINT ® RA III
WARNING
code
HdP – The value of parameter HdA is
too low.
HdP – Probe BT1, the dew point
temperature is too high.
LdP – Probe BT1, the dew point
temperature is too low.
The condensate drain is defective or
faulty
drn – The electrical wiring between
condensate drain and Electronic Control
Unit is interrupted.
Compressed air line is depressurised.
SrV– The maintenance time is expired
dt – Probe BT2, the temperature on
discharge side of refrigerant compressor
is too high.
LEP – Transducer BLP, the evaporating
pressure of the refrigerant fluid is too
low.
HCP – Transducer BHP, the condensing
pressure of the refrigerant fluid is too
high.
Cause
Original installa�on and opera�on manual
Action
Increase the value of parameter.
Refer to section "16.2 Specific
malfunctions" on page 112, "Probe BT1,
dew point temperature too high".
Refer to section "16.2 Specific
malfunctions" on page 112, "Probe BT1,
dew point temperature too low".
Consult the BEKOMAT
®
operation manual.
Restore the electrical wiring.
Pressurise the compressed air line.
Refer to section "10.2 Maintenance
work" on page 89.
Refer to section "16.2 Specific
malfunctions" on page 112, "Probe BT2,
compressor discharge temperature too
high".
Refer to section "16.2 Specific
malfunctions" on page 112, "Transducer
BLP, evaporating pressure of refrigerant
fluid too low".
Refer to section "16.2 Specific
malfunctions" on page 112, "Transducer
BHP, condensing pressure of refrigerant
fluid too high".
Installation and
109 | 118