Table of Contents
Advertisement
DRYPOINT
®
RA III
16. Troubleshooting
INFORMATION
INFORMATION
16.1 Warnings and alarms
16.1.1 Resetting a WARNING
NOTE
INFORMATION
Applicable documents
Following applicable documents are necessary and available:
•
BEKOMAT
Installation and operation manual.
®
•
Wiring diagrams.
Applicable documents
This section contains solutions to the most probable malfunctions/faults. In any
case, it is not possible to predict in advance all possible malfunction/failure
situations of the device.
In the event of any malfunctions / faults which are not described here,
malfunctions which cannot be acknowledged / eliminated or other related
questions, contact BEKO Technologies customer service. Refer to section "1.1
Contact" on page 6.
Resetting a WARNING with the device in remote mode
If the device operates in remote mode (drC parameter = YES or Modbus), is not
possible to reset a WARNING.
To reset a WARNING, the device must be switched in local mode.
•
Refer to section "9.3.8 User parameters" on page 83 and set the
drC parameter = NO
•
After resetting the WARNING, set again the device in remote mode.
Re-initializing of maintenance timer
Maintenance timer can be re-initialized to its present value at any time,
independently from the expiring of time.
Original installa�on and opera�on manual
107 | 118
Advertisement
Table of Contents
