Resetting An Alarm - Beko DRYPOINTRA III 20 Translation Of Original Installation And Operation Manual

Original installa�on and opera�on manual

16.1.2 Resetting an ALARM

NOTE
1. Refer to the section "3.2 User Interface" on page 29.
Refer to the section "9.3.6 ALARM status" on page 80.
2.
Fix the cause which has triggered the ALARM.
3.
The status LED ALARM [L13] is lit.
4.
Press 2 times the ENTER/CONFIRM button [B6].
5.
The status LED ALARM [L13] goes out.
6.
110 | 118
Resetting an ALARM with the device in remote mode
If the device operates in remote mode (drC parameter = YES or Modbus), is not
possible to reset an ALARM.
To reset an ALARM, the device must be switched in local mode.
•
Refer to section "9.3.8 User parameters" on page 83 and set the drC
parameter = NO
•
After resetting the ALARM, set again the device in remote mode.
Resetting an ALARM
DRYPOINT ® RA III