Decommissioning Work - Beko DRYPOINTRA III 20 Translation Of Original Installation And Operation Manual

Original installa�on and opera�on manual

13.2 Decommissioning work

For decommissioning work to be carried out, the following protective equipment must be always worn.
Tools
•
No tool necessary
Slowly close the air inlet valve and secure it against unintentional opening.
1.
Slowly close the air outlet valve and secure it against unintentional opening.
2.
Wait few minutes and then stop the product pushing for 3 seconds the START-STOP button
3.
on the User Interface. Refer to section "3.2 User Interface" on page 29.
Water-cooled models: interrupt the cooling water supply and secure it against unintentional
4.
opening.
Turn off the power acting on the ON-OFF switch. Refer to section
5.
"3.1 Product overview" on page 18.
Interrupt the mains supply and secure it against being established back on again
6.
unintentionally.
Depressurise the air circuit on the product.
7.
Depressurise the water circuit on the product.
8.
100 | 118
Prerequisites
Material
•
No material necessary
Decommissioning work
DRYPOINT
Protective equipment
® RA III