Table of Contents
Advertisement
Original installa�on and opera�on manual
9.3.6
ALARM status
The ALARM is an anomalous event related to a malfunction or a fault of the device. The ALARM always stops
the device to ensure the safety of the device and operators.
NOTE
INFORMATION
80 | 118
ALARM status
With the device in ALARM status the compressed air will not be treated.
•
Call immediately the maintenance personnel if one or more ALARMS are
detected.
•
Maintenance personnel will refer to section "16 Troubleshooting" on
page 107.
Behaviour of the device in presence of an ALARM
•
With the device stopped: the triggering of an ALARM, normally, is not
shown on the User Interface. In a presence of an ALARM is not possible to
start the device. After a starting attempt, the ALARM code will be shown
on the User Interface and the device remain stopped.
•
With the device started: the triggering of an ALARM always stops the
device.
•
ALARMS LP, ICE, FLP are shown also with the device stopped.
DRYPOINT
®
RA III
Advertisement
Table of Contents
