Original installa�on and opera�on manual
13.2 Decommissioning work
For decommissioning work to be carried out, the following protective equipment must be always worn.
Tools
•
No tool necessary
1.
Slowly close the air inlet valve and secure it against unintentional opening.
2.
Slowly close the air outlet valve and secure it against unintentional opening.
Wait few minutes and then stop the product pushing for 3 seconds the START-STOP button
3.
on the User Interface. Refer to section "9.3 Overview of User Interface after power ON" on
page 60.
Water-cooled models: interrupt the cooling water supply and secure it against unintentional
4.
opening.
Turn off the power acting on the ON-OFF switch. Refer to section "3.1 Product overview" on
5.
page 19.
Interrupt the mains supply and secure it against being established back on again
6.
unintentionally.
7.
Depressurise the air circuit on the product.
8.
Depressurise the water circuit on the product.
98 | 120
Prerequisites
Material
•
No material necessary
Decommissioning work
DRYPOINT
Protective equipment
®
RA III