Table of Contents
Advertisement
Operation
Levers for fixation of height and angle
3. Loosen the slider by using the lever in order to clamp the workpiece between the two cones or rolls.
Slider inclusive lever
4. Switch on the laser. The axis automatically moves over the middle of the rotary attachment.
5. Position the laser head over the workpiece at the position where you want to engrave.
6. Focus the object with the focus tool. The engraving area must be parallel to the X axis.
If necessary, do this with the aid of the angle adjustment. Do not touch the lens holder.
8.9.5
Gas-kit light
The compressed air connected to the Gas-Kit light must be dry and oil-free and may have a maximum of 10 bar at 150 lt/
min.
65
Advertisement
Table of Contents
