Responsibilities Of The Operating Personnel - Trotec Speedy 360 Operating Manual

The user is recommended to prepare company internal instructions considering the occupational qualifications
•
of the personnel employed in each case, and the receipt of the instruction/this manual or the participation in the
introduction/training should in each case be acknowledged in writing.
Keep the manual in the immediate vicinity of the machine so that it is accessible at all times to all persons working
•
on or with the machine.
Authority for the individual activities relating to the application of the machine (e.g. installation, operation,
•
maintenance and cleaning) must be clearly defined and observed, so that no unclear competencies result under
the aspect of safety. This applies in particular to work to be performed on the electrical equipment that may only be
performed by qualified specialists.
Maintenance and repair work as specified in the manual must be carried out regularly.
•
For all activities concerning installation, set-up, start-up, operation, modifications of conditions and methods of
•
operation, maintenance, inspection and repair, the switch-off procedures that may be provided in the manual must
be observed.
Provide appropriate personal protection equipment (e.g. protective goggles according to wavelength and laser
•
power).
The operator is responsible for the safety-related state of the machine.
•
Do not store any flammable materials in the working area or in the immediate vicinity of the device. Particularly,
•
residues of processed materials have to be removed to prevent any fire hazard.
The operator must ensure cleanliness and accessibility at and around the machine by corresponding instructions
•
and controls.
2.2.2

Responsibilities of the operating personnel

The operating personnel has the following responsibilities:
Always wear personal protective equipment.
•
The operator is required to check the machine including its safety devices for any externally detectable damage and
•
deficiencies before starting work, and to immediately report any changes (including irregularities of the operating
behavior) that may affect safety. It is important to ensure that the machine is only operated in perfect condition. For
details, see chapter "Maintenance".
The machine must not be le unattended while it is operating (supervised operation).
•
Switch off the machine described herein at the main switch for periods of non-use.
•
Operate the machine described here only with a lens in place. A missing lens may cause the unfocused laser beam
•
to be reflected out of the housing.
Stop this machine immediately in case of failure.
•
No working methods are permitted that affect the safety of persons or of the machine.
•
The machine and its components, such as the lens and mirrors, are to be kept clean at all times.
•
Caution
The adjustment of the beam path may only be carried out by service personnel of Trotec Laser GmbH.
Safety
17