Table of Contents
Advertisement
2.1.2
Improper use
Use of the machine for any purposes other than those intended or described in the present manual is regarded as
improper and therefore prohibited. Trotec Laser GmbH will not accept any liability for damage caused by improper use.
The operator is solely liable for all damages caused by improper use.
Non-observance of the operation, maintenance and service instructions described within this manual absolves Trotec
from any liability in case of a defect.
2.1.3
Residual risk
Even if all safety regulations are observed, a residual risk remains when operating the machine.
The measures required to reduce any residual risks can be found in the following sections of
(indirect)
hazards".
2.1.4
Machine modification
It is strictly prohibited to alter, refit or modify the machine in any way without the express consent of the manufacturer.
Likewise, it is strictly prohibited to remove, bridge or bypass any safety devices. Operating conditions and connection
and setup values stated in the data sheet must be complied with at all times.
Operation of the system is permitted only with original parts and accessories by the manufacturer. Use of third-party
parts affects machine safety.
2.1.5
Operating modes
NORMAL OPERATION
For normal operation, the following conditions must be met:
Intended use of the machine (see chapter
•
Operation by trained operating personnel.
•
Fully functioning and installed safety and protective devices.
•
Machine in perfect condition.
•
Processing of permissible materials according to the material lists.
•
Maintenance and service are not included.
•
Notice
During normal operation it is not necessary to wear safety glasses.
"Intended
use".
Safety
chapter"Secondary
13
Advertisement
Table of Contents
