Table of Contents
Advertisement
Operation
Caution
The maximum value at the pressure flow indicator must not exceed 0.4MPa. In case of non-compliance,
the tubing or lens may be damaged.
MAINTENANCE NOTE:
The filters of the Gas-Kit light (maintenance unit) must be checked regularly for liquid formation. This liquid would be
blown onto the material, reach the lens and contaminate it.
–
Check air pressure preparation!
–
Only connect dry and oil-free compressed air.
If you have any questions, please contact our experienced technical support in your area.
8.9.6
Temperature sensor
The temperature sensors ensure reliable temperature monitoring of the interior of the machine and are available as
additional option.
If a preset temperature value is exceeded, an acoustic alarm continuously sounds to warn the operator of abnormal
temperature trends during processing.
Warning
Fire hazard
The acoustic alarm upon startup of the machine indicates that the sensors are operating properly.
However, the sensors do not guarantee fire prevention.
–
The unit must not operate unattended despite the integrated temperature sensors.
–
If the acoustic alarm does not sound when the machine is switched on, check the functionality of the
sensors.
–
In case of questions, contact our experienced Technical Support in your local area.
66
1. To adjust the air pressure, li the adjustment knob of the air
pressure regulator and turn it until the air pressure display shows
the desired value.
2. Lock the set pressure by pressing the adjustment knob downwards
again.
Notice
Turn the regulator to a maximum of 0.4 MPa.
Advertisement
Table of Contents
